ReadMe.txt for the YLCDRX63NE start project.

This project was built for IAR Workbench for RX V4.10A.

Supported hardware:
===================
The sample project for Renesas RX63N is prepared
to run on a Renesas YLCDRX63NE starter-kit, but may be used on other
target hardware as well.

Using different target hardware may require modifications.


Configurations:
===============
- Debug:
  This configuration is built for a little endian target.
  It is prepared for debugging and downloading using the J-Link RX emulator.
  To use SEGGER SystemView with this configuration, configure
  SystemViewer for RX63N as target device and JTAG at 2000 kHz
  as target interface.

- Release:
  This configuration is built for a little endian target.
  It uses an embOS release library.
  It is prepared for downloading using the J-Link RX emulator.
