ReadMe.txt for the NXP K66FN2M0 start project.

This project was built for Rowley CrossWorks V4.7.1.

Supported hardware:
===================
The sample project for the K66FN2M0 is prepared to run
on a SEGGER emPower board. Using different target hardware 
may require modifications.

Configurations:
===============
- Debug:
  This configuration is prepared for download into internal
  Flash using J-Link. An embOS debug and profiling library
  is used.
  To use SEGGER SystemView with this configuration, configure
  SystemViewer for MK66FN2M0XXX18 as target device and SWD at
  2000 kHz as target interface.

- Release:
  This configuration is prepared for download into internal
  Flash using J-Link. An embOS release library is used.

Note:
=====
Please make sure your device is unlocked before downloading
your application. To do so follow these steps:
- Connect your device with the J-Link
- Open the J-Link Commander
- Type: "unlock Kinetis"
Now the Kinetis device is unlocked and you are able to
download your application.
