ReadMe.txt for the ST STM32F756 start project.

This project was built for Rowley CrossWorks V4.7.1.

Supported hardware:
===================
The sample project for the STM32F756 is prepared to run on
an STM32756G Eval board. Using different target hardware
may require modifications.

Configurations:
===============
- Debug:
  This configuration is prepared for download into internal
  Flash using J-Link. An embOS debug and profiling library
  is used.
  To use SEGGER SystemView with this configuration, configure
  SystemView for STM32F756NG as target device and SWD at
  2000 kHz as target interface. In addition, the RTT buffer
  address must be specified with this target (in case of doubt,
  search for _SEGGER_RTT in the respective mapfile).

- Release:
  This configuration is prepared for download into internal
  Flash using J-Link. An embOS release library is used.

Note:
=====
This project uses an embOS library with the workaround for
the ARM erratum 837070. If you have a device which does not
use the ARM core revision r0p0 or r0p1 you can also use the
according embOS library without the workaround.
Please have a look in the core/compiler specific embOS manual
for more details.