ReadMe.txt for the Arrow LPC-4350 start project.
This project was built for IAR Embedded Workbench for ARM V8.11.1.

Supported hardware:
===================
The sample project for the NXP LPC4350 CPU is prepared to run on
an Arrow LPC-4350-DB1 Development eval board, but may be used on
other target hardware as well.
Using different target hardware may require modifications.

Configurations
==============
- Debug:
  This configuration is prepared for download into external
  NOR Flash using J-Link. An embOS debug and profiling library
  is used.
  To use SEGGER SystemView with this configuration, configure
  SystemViewer for LPC4350_M4 as target device and SWD at
  1000 kHz as target interface.

- Release:
  This configuration is prepared for download into external
  NOR Flash using J-Link. An embOS release library is used.

- Debug_iRAM:
  This configuration is prepared for download into internal
  RAM using J-Link. An embOS debug and profiling library
  is used.
  To use SEGGER SystemView with this configuration, configure
  SystemViewer for LPC4350_M4 as target device and SWD at
  1000 kHz as target interface.

Notes
=====
IAR Embedded Workbench for ARM V8.11.1 utilizes a J-Link script file
that is shipped with the workbench itself. It is located at
$TOOLKIT_DIR$\config\debugger\NXP\LPC4350_DebugCortexM4.JLinkScript.

That file, however, can no longer be used with recent versions of the J-Link
software. A modified version of that file is shipped inside the root folder of
this embOS BSP and may be used to overwrite the previous version inside the
IAR installation directory.

It is recommended to create a back-up of the previous file before exchanging it
with the version shipped with this embOS BSP.