ReadMe.txt for the NXP (Freescale) iMX6UL start project.

This project was built for IAR Embedded Workbench for ARM V8.11.1.

Supported hardware:
===================
The sample project for the iMX6UL is prepared to run on
a NXP (Freescale) MCiMX6UL-EVK board. Using different target
hardware may require modifications.

Configurations:
===============
- Debug:
  This configuration is prepared for download into internal
  RAM using J-Link. An embOS debug and profiling library
  is used.

- Release:
  This configuration is prepared for download into internal
  RAM using J-Link. An embOS release library is used.

Notes:
======
For the MCIMX6UL-EVK, JTAG is by default dedicated with Audio
Codec signals. To use the JTAG debug connector (J1902) with
debug probes such as JLink, resistors R1407 and R1431-R1434
must be desoldered.
For further information, refer to "i.MX 6UltraLite EVK Board
Hardware User’s Guide" (Document Number IMX6ULEVKHUG, Rev. 1,
03/2016), p. 14, chapter 2.14 "JTAG connector (J1902)".
