In addition to its traditional Windows graphical user
interface (GUI), J-Flash supports a command line mode as well. This
makes it possible to use J-Flash for batch processing purposes. All
important options accessible from the menus are available in command
line mode as well. If you provide command line options, J-Flash will
still start its GUI, but processing will start immediately.
This screenshot below shows the command line help dialog, which is
displayed if you start J-Flash in a console window with
JFlashARM.exe -help or JFlashARM.exe
-? |
 |
This section lists and describes all available command
line options. Some options accept additional parameters which are enclosed
in angle brackets, e.g. . If these parameters are optional
they are enclosed in square brackets too, e.g. [<SADDR>]. Neither
the angel nor the square brackets must be typed on the command line, they
are used here only to denote (optional) parameters. Also, please note
that a parameter must follow immediately after the option, e.g.
JFlashARM.exe -openprjC:\Projects\Default.jflash.
| -openprj<FILENAME> |
Open an existing project file. |
| -saveprjas<FILENAME> |
Save the current project in the specified file. |
| -saveprj |
Save the current project. |
| -open<FILENAME> [,<SADDR>] |
Open a data file. Please note that the <SADDR> parameter
applies only if the data file is a *.bin file. |
| -saveas<FILENAME> [,<SADDR>,<EADDR>] |
Save the current data file into the specified file. Please note
that the parameters <SADDR>,<EADDR> apply only if the data
file is a *.bin file or *.c file. |
| -save[<SADDR>,<EADDR>] |
Save the current data file. Please note that the parameters <SADDR>,<EADDR>
apply only if the data file is a *.bin file or *.c file. |
| -relocate<OFFSET> |
Relocate data by the given offset. |
| -delrange<SADDR>,<EADDR> |
Delete data in the given range. |
| -eliminate |
Eliminate blank areas in data file. |
| -connect |
Connect to target. |
| -disconnect |
Disconnect from target. |
| -softlock |
Lock (soft) selected sectors. |
| -softunlock |
Unlock (soft) selected sectors. |
| -hardlock |
Locks (hard) selected sectors. |
| -hardunlock |
Unlocks (hard) selected sectors. |
| -checkblank |
Blank check target. |
| -erasesectors |
Erase selected sectors. |
| -erasechip |
Erase the entire flash chip. |
| -programverify |
Program and verify target. |
| -program |
Program target. |
| -auto |
Erase, program and verify target. |
| -readsectors |
Read selected sectors. |
| -readchip |
Read entire flash chip. |
| -readrange<SADDR>,<EADDR> |
Read specified range of target memory. |
| -startapp |
Start target application. |
| -exit |
Exit J-Flash. |
| -help |
Display help dialog. |
| -? |
Display help dialog. |
JFlashARM.exe
-openprjC:\Projects\Default.jflash -openC:\Data\data.bin,0x100000
-auto -exit
|
JFlashARM.exe
-openprjC:\Projects\Default.jflash -readsectors
-saveasC:\Data\data.bin,0x100000,0x10FFFF
|
J-Flash:
Command line interface
