GUIDRV_Fujitsu_16
Head office Germany 
US office 
emWin driver GUIDRV_Fujitsu_16
This driver supports the Fujitsu Graphic display controllers. It has been tested with "Jasmine", but it should also work
with "Lavender", since all relevant registers are compatible.
Supported hardware
Controllers
| # | Display controller | Add. info |
|---|---|---|
| 8720 | Jasmine | Fully optimized, LUT is initialized |
| 8721 | Lavender | Fully optimized, LUT is initialized |
Bits per pixel
Supported color depths are 1, 2, 4, 8 and 16 bpp.
Interfaces
The driver has been tested with a 32 bit interface to the CPU. If a 16 bit interface is used, the 32-bit accesses can be
replaced by 2 16-bit accesses.
Display data RAM organization
The display controller uses DRAM in an optimized, non-linear way (described in the Fujitsu documentation).
Direct memory access is not used by the driver.
RAM requirements of the driver
About 16 bytes for some static variables.
Additional driver functions
None.
Hardware configuration
This driver requires a direct interface for hardware access. The following table lists the macros which must be
defined for hardware access:
| Macro | Explanation |
|---|---|
| LCD_READ_REG | Read a register of the display controller. (as 32 bit value) (optional) |
| LCD_WRITE_REG | Write a register of the display controller. (as 32 bit value) (optional) |
The driver contains a default for hardware access macros, which configures 32 bit access on the Fujistu demonstration
platform (Using an MB91361 or MB91362 and a Jasmine chip at address 0x30000000); if the target hardware is
compatible with these settings, then LCD_READ_REG(), LCD_WRITE_REG() do not need to be defined.
Color format (R/B swap)
It seems that on some target systems, Red and blue are swapped. This can be changed via software if the Config
switch LCD_SWAP_RB is toggled in the configuration file.
Hardware initialization
The display controller requires a complicated initialization. Example code is available from Fujistu in the GDC module.
This code is not part of the driver, since it depends on the actual chip used, on the clock settings, the display and a lot
of other things.
We recommend using the original Fujitsu code, since the documentation of the chips is not sufficient to write this code.
Before calling GUI_Init(), the GDC should be initialized using this code (typically called as GDC_Init(0xff)).
Example:
LCDConf.h for VGA display, 8bpp, Jasmine:
#define LCD_XSIZE 640 /* X-resolution of LCD, Logical coor. */
#define LCD_YSIZE 480 /* Y-resolution of LCD, Logical coor. */
#define LCD_BITSPERPIXEL 8
#define LCD_CONTROLLER 8720 /* Jasmine */
Additional configuration switches
The following table shows optional configuration macros available for this driver:
| Macro | Explanation |
|---|---|
| LCD_ON | Function replacement macro which switches the display on. |
| LCD_OFF | Function replacement macro which switches the display off. |
Special requirements
None.
