ADuC7026
Head office Germany 
US office 
ADuC7026 Eval board
Controller:
- ADUC7026 G3U/I3R (G-Chip or I-Chip)
CPU:
- ARM7TDMI
Board main features:
- 2-Layer PCB (4" x 5" form factor)
- 9 V power supply regulated to 3.3 V on board
- 4-pin UART header to connect to RS-232 interface cable
- 20-pin standard JTAG connector to connect to ULINK emulator
- Demonstration circuit
- 32.768 kHz watch crystal to drive the PLL clock
- ADR291 2.5 V external reference chip
- Reset/Download/IRQ0 push-buttons
- Power indicator/general-purpose LEDs
- Access to all ADC inputs and DAC output from external header. All device ports are brought out to external header pins.
- Surface-mount and through hole general-purpose prototype area
- External memory and latch footprint
Controller main features:
- 32/16-bit RISC architecture (ARM v4T)
- 32-bit ARM instruction set for maximum performance and flexibility
- 16-bit Thumb instruction set for increased code density
- Unified bus interface, 32-bit data bus carries both instructions and data
- Three-stage pipeline
- 32-bit ALU
- Very small die size and low power consumption
- Coprocessor interface
- EmbeddedICE-RT real-time debug unit
- JTAG interface unit
- Interface for direct connection to Embedded Trace Macrocell (ETM)
Subscribe to Analog Devices ADuC 7026 eval software notification 