Rowley CrossWorks

In order to use J-Link with Rowley CrossWorks install the latest SEGGER software and documentation pack. Please verify that your J-Link software is up to date.

After that, start CrossWorks and open your project.

• Press Ctrl+Alt+T to open the "Targets" window, which shows a list of debug probes supported by Rowley CrossWorks
• Select and connect to Segger J-Link from the "Targets" window as shown below
  
• Press Ctrl+Alt+W to open the "Target Properties" window
• Set the location of the latest J-Link DLL file which comes with the software and documentation pack.
  

Now you are ready to go

Now you can start debugging and use J-Link with Rowley Crossworks. Please note that some ARM cores require an init file to be executed before debugging can start; this init file typically initializes certain parts of the ARM chip (memory access) that are required for the RAM to function.